The online newspaper for the forest products industry including loggers, sawmills, remanufacturers and secondary wood processors.
 
Safety Alert: Dead Trees are Manual Felling Hazards

An ash tree broke off five to six feet from the ground and struck a logger''s chain saw and his lower right leg.

By Staff
Date Posted: 7/1/2016


BACKGROUND:

                On a winter afternoon in the Appalachians, a timber cutter was felling hardwood timber with a chain saw. The terrain was fairly level, but there were several inches of snow on the ground and a dense understory of beech trees and brush.

 

PERSONAL CHARACTERISTICS:

                The timber cutter was a co-owner of his logging business. He was in his early to mid-thirties and was experienced and trained. He was wearing all required personal protective equipment.

 

UNSAFE ACTS AND CONDITIONS:

                The logger was manually felling timber in a partial-cut operation where there were scattered species of trees that had die-back conditions in the overstory. The landowner had instructed him to leave the trees that were not marked for harvest standing.

                The logger used proper directional felling techniques to guide the fall of a standing medium-size cherry tree, but his aim in creating the hinge was probably slightly off. Approximately 35-40 feet away, close to the direction of the tree’s fall, was a standing dead ash sawtimber tree.

                As he completed the cut, the logger retreated in the opposite direction from the tree’s fall. Due to the amount of snow and brush, and a downed, previously felled tree he had to step over, his retreat was somewhat slow.

 

ACCIDENT:

                The top of the falling tree brushed against the standing, dead ash tree, causing the ash to sway back and forth. As it whipped backward toward the timber cutter, the ash tree broke off five to six feet from the ground and struck his chain saw and his lower right leg.

 

INJURY:

                The tree broke the logger’s lower right leg. His in-woods rescue was somewhat delayed because the logging business partner had to drive out to a main road (where the cell phone signal was stronger) to meet EMS and direct them over minor roads and to the site; the remote location and weak phone signal prevented the EMS crew from finding the job on their own.

                It was two months before he began working in the woods again.

 

RECOMMENDATIONS:

                OSHA logging regulations specify that “Each danger tree, including lodged trees and snags, shall be felled or removed using mechanical or other techniques that minimize employee exposure before work is commenced in the area of the danger tree. If the danger tree is not felled or removed, it shall be marked and no work shall be conducted within two tree lengths of the danger tree unless the employer demonstrates that a shorter distance will not create a hazard for an employee.”

                Leaving dead trees standing presents an especially high risk with manual felling. If there is any doubt about the safety of a tree falling and striking dead limbs or dead trees in the area, the manual feller should ask the skidder operator to knock the tree down the rest of the way.

                Plan, clear, and use a retreat path leading diagonally back from the intended direction of fall of the tree, and take repeated glances at the crown of the falling tree during the retreat, continuing to walk briskly until well away from the stump of the falling tree.

                Source: Forest Resources Association




 






Do you want reprints or a copyright license for this article?   Click here


Research and connect with suppliers mentioned in this article using our FREE ZIP Online service.


Copyright 2017, IndustrialReporting, Inc.
10244 Timber Ridge Dr., Ashland, VA 23005
Phone: (804) 550-0323 or FAX (804) 550-2181
Terms of Use     Contact our Staff